Kemper reamp spdif stereo5/21/2023 ![]() ![]() Set the input on this track to SPDIF or your master output. Stop the playback and create another track. As soon as you press play on your DAW, you should hear the guitar DI being fed to the Kemper. Go to the input section and change the input source to either "Return input reamp" or "SPDIF input reamp". However, avoid a deep orange or red colour, which could result in clipping in the DI signal.ģ) Reamping You should have an SPDIF cable hooked up from your interface to the SPDIF input of the Kemper, or a TS cable from the interface to the return input of the Kemper. ![]() The input LED is a helpful indicator in this regard: it should flash yellow consistently when hitting the strings hard. This basically ensures that the git studio output is perfectly leveled while keeping the noise floor down - adjusting the dynamics of the instrument to the digital headroom of the profiler. ![]() Using Git/Stack in the output section would be useful in such a situation, as would having more inputs on your interface. Click on the input menu and adjust the clean sense parameter to a level where clean sounds have the same loudness as the distorted sounds. You could always set the SPDIF to git studio and the master output to master stereo or vice versa if you have enough inputs on your interface.Ģ) Adjust the DI output level: This is the commonly ignored step that leads people to get into trouble when their DI recording is not hot enough/too hot for the reamping process, which causes trouble down the line. Alternatively, if you want to hear the effected sound on the right channel and the DI signal on the left, set the mode to Git/Stack. Seen a few threads complaining about sub-par replication of tones when reamping and thought it would be prudent to have a step-by-step guide on how to set up your Kemper for reamping, since no one RTFMġ) Set channel for DI signal: You can do this by choosing your preferred reamp channel (SPDIF, main output) in the output section. ![]()
0 Comments
Leave a Reply. |